The appearance and usability of your kitchen or bathroom can be greatly improved by installing a mixer tap or a basin mixer tap. Homeowners like these taps because they are convenient in that they blend hot and cold water. This comprehensive tutorial will assist you if you are thinking about doing a DIY installation.
Equipment and Supplies You’ll Require
Before beginning to install your mixer tap or basin mixer tap, make sure you have the necessary tools and supplies on hand. A basin or mixer tap, an adjustable wrench, and a screwdriver are required for installation.
To catch any leftover water that might flow out during installation, a bucket will come in handy. If you’d like, silicone sealant can also be used to enclose the tap’s base in a waterproof layer. You will be set to begin the installation once you have these equipment and supplies ready.
- Turn Off the Water Supply: Make sure the water supply to the tap is turned off before beginning the installation. Under the sink, find the shut-off valves and rotate them in a clockwise direction. To remove any last bits of water in the pipes, it’s also a good idea to turn on the faucet.
- Remove the Old Tap: It is necessary to remove the old tap before replacing it. Disconnect the water supply pipes from the old tap using the adjustable wrench. The tap’s mounting nuts should then be removed from the sink. After detaching everything, remove the outdated faucet.
- Clean the Sink Area: Make sure the sink area is spotless before installing the new mixer tap or basin mixer tap. To make sure the surface is clean and level for the new installation, remove any debris or old plumber’s putty.
- Install the Mixer Tap or Basin Mixer Tap: To install the mixer tap or basin mixer tap, start by placing it in the designated hole in the sink, ensuring it fits securely without wobbling. Next, secure the tap by threading the mounting nuts onto the tap shank from underneath the sink, tightening them by hand first and then using an adjustable wrench for a snug fit. Just be careful not to overtighten, as this can damage the sink or tap.
- Check for Proper Functioning: After all the connections are made, open the water supply valves beneath the sink. To look for leaks around the connections, open the mixer tap. If any leaks are found, shut off the water supply and continue tightening the connections until the leaks stop.
- Test the Mixer Tap: Check for leaks before testing the mixer tap. Check the temperature and flow of the water by running the tap for a few minutes. Make necessary adjustments to the hot and cold handles to make sure the mixing mechanism is operating properly.
- Seal the Base: To create a watertight barrier, if preferred, run a tiny bead of silicone sealant around the base of the mixer tap or basin mixer tap. This step, particularly if you have a countertop sink installation, helps stop water from leaking under the sink.
Conclusion
Installing a basin mixer tap or mixer tap is a quick and easy procedure that only requires a few basic steps to finish. The practicality and aesthetics of your kitchen or bathroom can be improved with the correct supplies and a little perseverance.
Enjoy the ease of your new mixer tap and don’t forget to take your time and double-check your connections! Whether you’re updating or replacing an outdated light, this do-it-yourself project will enhance your house and save you time and money.
